INSTRUCTIONS FOR USE Pro-Ject 2 Xperience Acryl Pro-Ject 2 Xperience Classic
5 2 © Audio Trade GmbH · Pro-Ject 2 Xperience Acryl / Classic / Ortofon 2M Red · Revision 2012.7.
Pro-Ject 2 Xperience Acryl / Classic Controls, features and connections 1 2 3 5 6 7 8/18 9 10 11 12 13 14 15 16 17 20 21 22 23 Motor transport locks Stepped drive pulley Drive belt * 3a Hook * Sandwich platter * Tonearm counterweight * 6a Downforce scale Tonearm lift lever Tonearm rest and removable transport lock Tonearm tube 9a Tonearm base Lid * Lid hinges Hinge fasteners Power supply socket Phono output sockets and earth connection Anti-skating weight adjustment scale Anti-skating weight * Anti-skating
Set-up The deck is supplied partially disassembled and carefully packaged for safe transport. Carefully remove all parts from the transport packaging. Screw the three feet (23) onto the threaded bolts located on the underside of the plinth. Make sure the surface you wish to use the turntable on is level (use a spirit level) before placing the turntable on it. Remove the two red transport screws (1) which secure the motor (22) during transportation.
Anti-skating force adjustment The anti-skating force must be adjusted corresponding to the downforce as follows: Downforce Groove in the stub (15) 10 - 14mN 1st from bearing rings 15 - 19mN 2nd " " " rd 20mN and bigger 3 " " " Hang the loop of the thread of the anti-skating weight in the groove of the anti-skating stub (15) corresponding to the downforce applied to your cartridge and feed the thread through the loop of the wire support (17).
! Always disconnect the record player from the mains power supply as a precaution before maintenance! Fitting and connecting the cartridge ** All cartridges with half inch mounting holes can be fitted. Leaving the needle's protection cover on, fit the cartridge to the headshell using the screws supplied with the cartridge by passing one screw through each slot in the headshell (21). Do not tighten the nuts yet.
Potential incorrect use and fault conditions Pro-Ject turntables are manufactured to the highest standards and undergo strict quality controls before leaving the factory. Faults that may possibly occur are not necessarily due to material or production faults but can sometimes be caused by incorrect use or unfortunate circumstances. Therefore the following list of common fault symptoms is included. The platter doesn't turn although the unit is switched on: The unit is not connected to the mains power supply.
Accessories Tonearm counterweight Lid 2 motor transport screws (marked red) Feet Feet Tonearm transport lock Power supply Platter ! 8 Please remove feet bevore repacking © Audio Trade GmbH · Pro-Ject 2 Xperience Acryl / Classic / Ortofon 2M Red · Revision 2012.7.