INSTRUCTIONS FOR USE Pro-Ject Debut Carbon DC
© Pro-Ject Audio Systems · Pro-Ject Debut Carbon / Ortofon OM 10 and Ortofon 2M Red · Revision 2014.03.
Dear music lover, thank you for purchasing a Pro-Ject Audio record player. In order to achieve maximum performance and reliability with this record player you should study these instructions for use carefully. ** Your turntable has been delivered with a factory fitted and adjusted cartridge. Please ignore the cartridge set up instructions unless changing the cartridge at a later date. During assembling and adjusting of the deck, small parts could be lost if not carefully placed in a suitable receptacle.
Set-up The deck is supplied partially disassembled and carefully packed to guarantee a safe transport. Remove all parts from the transport packaging carefully. Make sure the surface you want to place the turntable is levelled (use a spirit level). Remove the transport lock (18) from the tonearm. Store it in the original packaging so it is available for future transportations. Fit the drive belt (3) around the hub (4) and the smaller diameter part of the motor pulley (2).
The recommended load impedance for the factory fitted cartridges is: 47kohms /MM-input Mains power connection The turntable is supplied with the universal power supply with 3 exchangeable sockets adapters suitable for all countries. Select the correct adapter for your country and insert the adapter to the exchangeable part of the power supply. Connect the low voltage plug from the power supply to the socket (13) on the rear of the record player before connecting the power supply to the mains.
Please note: Under no circumstances should the arm tube be adjusted with the needle still in the record groove! Irreparable damage may be caused to the cantilever suspension! The arm must be lifted to make each adjustment and lowered afterwards to check it. Mounting and connecting the cartridge ** All cartridges with half inch mounting holes can be fitted. Leave the needle's protection cover on and put the cartridge on the headshell by using the cartridge supplied screws.
Dimensions (W x H x D) Weight 415 x 118 x 320mm, dust cover open 415 x 365 x 405mm 5,6kg Technical specifications MM-Cartridge Ortofon OM 10 Frequency range Channel separation Output voltage Recommended load impedance Compliance/stylus type Recommended tracking force Weight 20-22.
Potential incorrect use and fault conditions Pro-Ject Audio Systems turntables are manufactured to the highest standards and undergo strict quality controls before leaving the factory. Faults that may possibly occur are not necessarily due to material or production faults but can sometimes be caused by incorrect use or unfortunate circumstances. Therefore the following list of common fault symptoms is included.
© Pro-Ject Audio Systems · Pro-Ject Debut Carbon / Ortofon OM 10 and Ortofon 2M Red · Revision 2014.03.