User Manual

SETUP

Platter and drive belt installation

Please remove drive belt from accessories box and install it as shown in the following ilustration. Put the

felt mat on the top of the platter.

Cartridge installation, stylus exchange

* If you purchased this turntable in a package that included the cartridge, this has already been done for

you.

Install the cartridge into the headshell, using the appropriate hardware included with your cartridge. All

cartridges with half inch mounting holes can be fitted.

Connect the cartridge as indicated below:

• White left channel L+

• Red right channel R+

• Green right channel R-

• Blue left channel L-

For correct cartridge alignment, use the two-point cartridge alignment protractor provided with your

Primary DC accessories. If unfamiliar with two-point setup, please refer to your dealer.

A damaged or worn stylus may harm your record collection and should be replaced.

Please remove stylus protection before pulling the stylus from the cartridge and replace for a new one.

Stylus type is exchange for pre-mounted cartridge Ortofon OM 5E: Stylus OM 5E. If in doubt, consult your

local dealer or distributor.