Manual

ManualsBrandsPro-Ject ManualsTurntablesPro-Ject Essential III White Gloss Turntable

INSTRUCTIONS FOR USE

Pro-Ject Essential III

Summary of content (8 pages)

PAGE 1
INSTRUCTIONS FOR USE Pro-Ject Essential III
PAGE 3
Essential III Controls, features and connections (1) POWER SWITCH (2) STEPPED DRIVE PULLEY (3) PLATTER & FELT MAT (4) TONEARM COUNTERWEIGHT (5) TONEARM LIFT LEVER (6) TONEARM REST (7) TONEARM TUBE (8) ANTI-SKATING STUB WITH ANTI-SKATING WEIGHT ADJUSTMENT SCALE (9) ANTI-SKATING WEIGHT SUPPORT HOOP (10) ANTI-SKATING WEIGHT WITH WIRE (11) HEADSHELL WITH FINGER LIFT AND PRE-MOUNTED ORTOFON OM10 (12) SIGNAL OUTPUT CABLE (13) POWER SUPPLY SOCKET (14) LID HINGES (15) HINGE FASTENERS (
PAGE 4
Dear music lover, Thank you for purchasing a Pro-Ject Audio Systems’ record player. In order to achieve maximum performance and reliability with this record player you should study these instructions for use carefully. Warning of a hazard for the user, the unit or possible misuse ! Important notice The following instructions for adjusting the cartridge are provided in case the cartridge is replaced by a different model at a later date.
PAGE 5
Anti-skating force adjustment Hang the loop of the thread of the anti-skating weight in the groove of the anti-skating stub (8) corresponding to the downforce applied to your cartridge and feed the thread through the loop of the wire support (9).
PAGE 6
Stylus exchange A damaged or worn stylus may harm your record collection and should be replaced. Please remove stylus protection before pulling the stylus from the cartridge and replace for a new one. Stylus type in exchange for pre-mounted cartridge Ortofon OM 10: Stylus OM 10. If in doubt consult your local dealer or distributor! Mounting and connecting the cartridge ** All cartridges with half inch mounting holes can be fitted.
PAGE 7
Potential incorrect use and fault conditions Pro-Ject turntables are manufactured to the highest standards and undergo strict quality controls before leaving the factory. Faults that may possibly occur are not necessarily due to material or production faults but can sometimes be caused by incorrect use or unfortunate circumstances. Therefore the following list of common fault symptoms is included. The platter doesn't turn although the unit is switched on: The unit is not connected to the mains power supply.