User manual

Line Out acts as a direct bypass when Line in input is selected. (Active also without power supply)

Alternatively, the built-in Bluetooth transmitter allows to relay signal from inputs (Phono or Line) to any BT

receivers such as Pro-Ject MaiA S2 (S3) or BT Box E (S2, S2 HD) or directly to Bluetooth speakers or

headphones. Transmitter connects to the receiver with strongest signal automatically.

If you want to connect it to a BT Box E (S2, S2 HD) it is important to connect the Phono Box E BT5 to the power

supply first. Otherwise it is possible, that the boxes are not able to connect. The boxes connect automatically.

If the connection is successful, you will hear a sound. Now you are able to use it.

Output signal is always present on both outputs (analogue and Bluetooth).

Mains power connection

Connect the low voltage plug from the power supply to the Power 18V socket of the phono amplifier before

connecting the power supply to the mains.

Technical specifications Pro-Ject Phono Box E BT5

Gain, MM: 34dB

SNR: 74dB

THD+N: 0,02% @ 1kHz

RIAA-equalisation curve accuracy: 20Hz - 20kHz / max. 0,5dB

BT transmitter: Version 5 (Class II), A2DP 2.1 support, aptX, aptX HD

BT range: 10 meters in direct visibility between source and receiver

Outboard power supply: 18V/500mA DC, suitable for your country's mains supply

Power consumption: 200mA DC

Dimensions W x H x D (D with sockets): 120 x 32 x 100 (106) mm

Weight: 280g without power supply

Potential incorrect use and fault conditions

No signal on one or both channels:

No connection between signal source and phono amplifier or amplifier. This could be due to a faulty

plug, broken wire or solder joint or simply loose plug/socket connection.

Strong hum:

No earth connection from cartridge or arm, or arm cable to phono amplifier, or earth loop.

Service

Should you encounter a problem which you are not able to alleviate or identify despite the above information,

please contact your dealer for further advice. Only when the problem cannot be resolved there should the unit

be sent to the responsible distributor in your country.