Specifications

Replay at 78 r.p.m.

** In order to replay shellac records at 78 r.p.m. your turntable must be equipped with the 78 r.p.m. pulley

which is available as an optional accessory for most models.

After fitting the 78 r.p.m. pulley please proceed as follows: Remove the platter and using the tool from the

accessory kit fit the belt around the larger diameter step of the pulley. Replace the Platter, start the turntable

at 33 r.p.m. and switch the speed to 45 r.p.m., the platter will then revolve at 78 r.p.m..

Fitting the 78 r.p.m. pulley

Before beginning work fit the cartridge’s needle protection cover.

Remove the platter and drive belt. Please remember that sweat or sticky fingers will impair the function of the

belt. Use a piece of kitchen paper or a cloth to remove the belt.

Measure the height of the pulley above the plinth in order to ease correct refitting.

Using a small screwdriver loosen the grub screw in the neck of the pulley just enough to remove the pulley

vertically without using force. Refit the pulley in the opposite order. Tighten the grub screw carefully making

sure you do not overtighten it.

Fit the drive belt around the subplatter and the pulley. Again, use a piece of paper or cloth to avoid soiling

the belt. Replace the platter.

** 78 r.p.m. is not available with the Essential (all models), Xperience Basic +, Xperience Comfort,

Xperience Acryl, Xperience Classic, Xperience SuperPack, PerspeX, PerspeX Anniversary, RPM 1.3

Genie, RPM 1.3 Genie SuperPack, RPM 9.1, RPM 9.1 SuperPack, RPM 9.1 Acryl, RPM 9.2 Evolution,

RPM 10.1 Evolution and Signature.

The models Debut III/Phono SB, Xpression III Comfort, RPM 5 SuperPack, RPM 5.1 SuperPack, RPM

6.1 SB, RPM 6.1 SB SuperPack and Xtension (all models) are equipped with the 78 r.p.m. pulley as a

standard.

Technical specifications Pro-Ject Speed Box S

Nominal speeds: * 33 and 45 r.p.m. ** Optional 78 r.p.m.

Quartz oscillator: Speed stability +/- 0,001%

*** Length power cable: approximately 40cm

Turntable connection: 16V/AC 190mA max. (3W power consumption max.)

Outboard power supply: 18V/500mA DC, suitable for your country's mains supply

Dimensions W x H x D (D with sockets): 103 x 36 x 104 (104)mm

Weight: 560g without power supply

Service

Should you encounter a problem which you are not able to alleviate or identify, please contact your dealer for

further advice. Only when the problem cannot be resolved there should the unit be sent to the responsible

distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions

for use. Modification or change to any part of the product by unauthorized persons release the

manufacturer from any liability over and above the lawful rights of the customer.

PRO-JECT is a Registered Trademark of H. Lichtenegger.

This guide was produced by: Audio Trade GmbH

The information was correct at the time of going to

press. The manufacturer reserves the right to make

changes to the technical specification without prior

notice as deemed necessary to uphold the ongoing

process of technical development.