Specifications

© Pro-Ject Audio Systems · Pro-Ject Xtension 9 Evolution · Revision 2014.11.14
7
Mains power connection
The turntable is supplied with the universal power supply with 3 exchangeable sockets adapters suitable for
all countries. Select the correct adapter for your country and insert the adapter to the exchangeable part of
the power supply.
Connect the low voltage plug from the power supply to the socket (1) on the rear of the record player before
connecting the power supply to the mains.
Fitting the lid
Fit the lid (dust cover 24) carefully over the hinge prongs and adjust the screws (23) until the lid stays open
where you want it to without being too stiff to open or close.
Starting the motor, changing replay speed
Press the button START to start the turntable. For change the speed from 33 r.p.m. to 45 r.p.m., please press
the START button again. Speed is correct, when the LED diode stops blinking. To switch turntable to STAND
BY mode, please hold the button START for 3 seconds.
Useful tips
The base and the record player should be positioned on a low-resonance surface such as wood or multiple
layer ply board to avoid structural vibrations disturbing replay.
Technical specifications
Pro-Ject Xtension 9 Evolution / Pro-Ject 9cc Evolution
Electronic speed change
33/45 rpm.
Speed variance
max. ±0,09 %
Wow and flutter
max. ±0,1 %
Signal to noise
73dB
Effective tonearm mass
8,5g
Effective tonearm length
9 " (230mm)
Overhang
16mm
Power consumption
4W/0W standby mode
Outboard power supply
15V / 0 - 0.8mA DC (set at 0.5mA), universal power supply
Dimensions (W x H x D)
465 x 185 x 350mm, dust cover open 465 x 440 x 420mm
Weight
18kg
Lenght Connect it connection cable
1,23 m
Capacity tonearm cable
65pF/meter
Maintenance and cleaning
Your record player requires little or no regular maintenance. Remove dust with a slightly moistened antistatic
cloth. Never use a dry cloth because this will create static electricity which attract more dust! Antistatic
cleaning fluids are available at specialist stores but must be applied sparingly to avoid damage to rubber
parts. It is recommended to fit the needle cover before cleaning or maintenance is carried out to avoid damage.
If the player is not used over a long period of time the drive belt can be removed to prevent unequal stretching.
!
Always disconnect the record player from the mains power supply as a precaution before maintenance!