Datasheet

ManualsBrandsPro Line Studio ManualsCamera Accessories780150

About Pro Line

Pro Line’s studio lighting equipment is recognised worldwide

as the leading brand of studio equipment for both the

professional and amateur photographer. The most innovative

technology, coupled with high quality manufacture and ease

of use puts Pro Line at the forefront for today’s studio or

location photographer.

PROLINE INTERNATIONAL

www.prolinestudio.co.uk

OPERATING INSTRUCTIONS

Summary of content (4 pages)

PAGE 1
About Pro Line Pro Line’s studio lighting equipment is recognised worldwide as the leading brand of studio equipment for both the professional and amateur photographer. The most innovative technology, coupled with high quality manufacture and ease of use puts Pro Line at the forefront for today’s studio or location photographer. OPERATING INSTRUCTIONS PROLINE INTERNATIONAL www.prolinestudio.co.
PAGE 2
Lighting Setups Below is a diagram of the basic 1, 2, 3 and 4 lighting setups. Each light is used for a specific purpose and are known as the Primary, Fill, Background, and Rim/Flair light. Primary – This is the main light in a setup, and in cases where it is used with other lights will normally be the brightest. 1. Modelling Light Switch 2. Power Indicator 3. Flash Power Control 4. Photo Cell Switch 5. Mains Power Switch 6. Sync Cable Socket 7. Power Socket 8. Flash Test Button 1. 360 Deg Photo Cell 2.
PAGE 3
Safety Notes Accessories Barn Doors Barn doors are designed to control the direction and spread of the light. They can also be used with coloured gels. The Apollo lights must not be used in an environment where moisture or flammable vapour is likely to come into contact with the unit. Avoid touching either the modelling or flash bulbs with bare hands. This will shorten the life of the bulb and cause it to blacken. Do not operate if the cord or unit has been damaged.
PAGE 4
Light Stand Replacing the Flash Tube Set up the light stand to the required height and remove the white plastic cap from the top. The legs should be positioned as far apart as possible in order to obtain the most stability. Umbrella Turn off the unit and disconnect from the mains supply and press the Flash Test Button in order to discharge any stored power. It is recommended that you wait 30 minutes before touching either the flash or modelling bulb.