User's Manual

Connection Setting: For PPPoE/PPPoA connection, you can select Always on or Connect

on-demand. Connect on demand is dependent on the traffic. If there is no traffic (or Idle) for a

pre-specified period of time, the connection will tear down automatically. And once there is traffic

send or receive, the connection will be automatically on.

IP Address: For PPPoE/PPPoA connection, you need to specify the public IP address for this

ADSL Router. The IP address can be either dynamically (via DHCP) or given IP address provide

by your ISP. For Static IP, you need to specify the IP address, Subnet Mask and Gateway IP

address.

NAT: Select this option to Activate/Deactivated the NAT (Network Address Translation) function

for this VC. The NAT function can be activated or deactivated per PVC basis.

[Dynamic Route]

RIP (Routing Information Protocol): Select this option to specify the RIP version, including

RIP1, RIP2-B and RIP2-M. RIP2-B & RIP2-M are both sent in RIP-2 format, the difference is that

RIP2-M using Multicast and RIP2-B using Broadcast format.

RIP Direction: Select this option to specify the RIP direction. None is for disabling the RIP

function. Both means the ADSL Router will periodically send routing information and accept

routing information then incorporate into routing table. IN only means the ADSL router will only

accept but will not send RIP packet. OUT only means the ADSL router will only sent but will not

accept RIP packet.

[Multicast]

IGMP (Internet Group Multicast Protocol): It is a session-layer protocol used to establish

membership in a multicast group. The ADSL supports both IGMP version IGMP-v1 & IGMP-v2.

Select None to disable it.

Your ISP should provide the above information. Note that you must enter the user name

exactly as your ISP assigned it. If the assigned name is in the form of user@domain where

domain identifies a service name, enter it exactly as given.

(4) Bridge Mode

The modem can be configured to act as a bridging device between your LAN and your ISP.

Bridges are devices that enable 2 or more networks to communicate as if they are 2 segments of

the same physical LAN. Please set the Connection type.