User's Manual

STEP3: Secure this card to the rear of the computer chassis and put back the cover.

STEP4: Secure the antenna to antenna connector of the card. Please refer to the illustration

below:

STEP5: Turn on the computer.

[Guidelines for the Hardware Installation]

Please observe the following guidelines when you are installing the PCI card to the

Desktop PC:

λ Avoid placing the PC close to obstacles

Obstructions such as concrete walls and thick limit radio signal penetration and reduce

the throughput and the coverage range of the PCI card.

λ Place the PC as high as possible

The higher the PC is placed, the better the performance.

λ Adjust the antenna position

The card has two antennas for signal reception and one antenna for high power signal

transmission. The antennas on the right and left side are for signal reception and should

be set perpendicular (90 degrees) to each other. The central one is for signal

transmission and should be pulled up about 45 degree. Please refer to the illustration

below: