User's Manual

2.2 Setting up Internet Access

This section describes how to setup Wireless Router Internet access through DSL or

cable modem.

For Windows OS

To access Internet via wireless router with Static IP method as example, the set up

procedures are showing below:

a) Access your ADSL Router Modem and configure the Internet setup (VPI, VCI, and

Encapsulation); and then, save the settings.

(PS. Most of ISP companies will set the

default internet setup already for the user).

b) Log in your wireless broadband router, Select “TCP/IP Setting” Section Î “WAN

Interface” Î Choose “Static IP”.

c) Enter “IP Address”, “Subnet Mask” and “Server IP Address”

d) In the below “DNS” option, select “Set DNS Manually” and enter the DNS Address

which is provided by your ISP; and then click “Apply Changes” button to save the

settings.

e) You can back to “Management” section Î “Status” to check the Internet status.

For Macintosh Clients

To access Internet via wireless router on Macintosh system, the set up procedures are

showing below:

a) Open the TCP/IP Control Panel.

b) Select Ethernet from the Connect via pop-up menu.

c) Select Using DHCP Server from the Configure pop-up menu. The DHCP Client ID

field can be left blank.

d) Close the TCP/IP panel and save your new settings.

If you decide to assign IP addresses manually instead of DHCP, set the Router

Address field with wireless router’s IP address and make sure DNS settings are

correct.

For Linux Clients

To access Internet via the wireless router, you need to set the wireless router as the

“Gateway”. Make sure login as “root” before attempting any changes.

Fixed IP Address

Most Linux installations use fixed IP address, if you wish to use a fixed IP address, make

sure make the following changes.

a) Set “Default Gateway” with the IP address of the wireless router.

b) Make sure DNS settings are correct.

To act as a DHCP Client (recommended)