Manual

Instructions for Installation:
1. Block the tires of the trailer and support trailer tongue.
2. The Fulton Powered A-Frame Jack has been designed to attach to the top surface of the A-frame coupler.
3. Disconnect the trailer battery ground trailer.
4. Place the jack outer tube through the A-frame coupler hole.
5. Attach the jack using three (3) 3/8” diameter, 1” long, grade 5 bolts, nuts and lock washers. Lock/star washers are
recommended to insure a metal-to-metal contact between jack and coupler for proper grounding. Torque bolts to 15-
20 ft-lbs.
6. Route the black wire lead from the plastic cover along the trailer to the battery. Attach the wire lead to the trailer
using cable ties or equivalent.
7. Connect the wire lead from the jack directly to the positive (+) terminal of the battery. This unit has a built-in circuit
breaker which automatically trips and resets. Reconnect the battery ground cable.
8. Check for proper installation, by activating the motor switch to ensure the jack travels in both directions.
F3653 (Rev-B 18050) 10/12
• This product must be installed and used in strict
accordance with these instructions. Purchaser/
owner must not alter or modify the product.
• Operator and bystanders should never position any
part of body under or on the path of any portion of
this product or the load being supported, or moved.
• Do not allow children to play on or around this
product or the load being supported, or moved.
• Never exceed the maximum rated capacity. Refer
to stamped markings or decals to obtain rated
capacity. If uncertain, contact Cequent Trailer
Products at 1-800-521-0510 or
www.cequentperformanceproducts.com
• Periodically check mounting hardware for proper
torque and tighten if necessary.
• Always replace bent, broken, or worn parts before
using this product.
• To avoid accidental shock and/or damage to the
electrical system, disconnect the battery ground
cable before installation.
• When using the drop foot or drop leg, make certain
the supplied pin is fully inserted through both sides
of the inner tube and the drop tube before using the
jack.
• Secure the load, vehicle and trailer from rolling (by
blocking wheels) when operating jack or coupling
trailer.
• These jacks are designed for vertical loading.
Excessive side forces may cause jack failure and
must be avoided.
• If this product has a drop foot or drop leg, never
attempt to adjust the drop foot or drop leg when
there is any load on the jack.
Failure to follow all warnings and instructions may result in product
failure, property damage, serious bodily injury, and/or death.
WARNING
Installation Instructions
Warning: Failure to follow all warnings and instructions may result in
product failure, property damage, serious bodily injury, and/or death.
Read, Understand, Follow and Save These Instructions
Read, understand and follow all instructions and warnings (Instructions) before installing and using this product. Install and use this product only as specified in
these instructions. Improper installation or use of this product may result in property damage, serious injury, and/or death. Never allow installation or use of this
product by anyone without providing them with these instructions. You must read, understand and follow all instructions and warnings for any product(s) to
which this product is used in conjunction with or installed. Save these instructions with the product for use as a reference for any future installation and use of
the product.
Powered A-Frame Jack
Extend / Retract
Motor Switch