Use and Care Manual

CME35 3.5 Cu Ft. Cement Mixer Assembly & Operating Instructions Manual
4
cover before unplugging the mixer. Disconnect from power supply when not in use, before moving,
making adjustments, changing parts, cleaning, or working on the mixer.
DO NOT FORCE TOOL
Always work within the rated capacity. Do not start the motor if the drum is fully loaded. Do not turn
mixer off while full of concrete. Do not use the mixer for a purpose for which it was not intended. The
mixer is not to be towed by any vehicle. NEVER LEAVE MIXER RUNNING UNATTENDED. Do not
leave mixer until it has come to a complete stop. DISCONNECT POWER.
PROTECT THE ENVIRONMENT
Take leftover materials to an authorized collection point or follow the stipulations in the country where
the mixer is used. Do not discharge into drains, soil or water.
STAY ALERT
Do not operate the mixer while under the influence of drugs, alcohol, or any medication that could affect
your ability to use it properly. Do not use this mixer when you are tired or distracted from the job at
hand. Watch what you are doing at all times. Use common sense.
SERVICE
Tool service must be performed only by qualified repair personnel. Service or maintenance by unqualified
personnel could result in a risk of injury.
When servicing a tool, use only identical replacement parts and follow instructions in the manual. Use
of unauthorized parts or failure to follow Maintenance Instructions may create a risk of shock or injury.
ASSEMBLY WARNING! - IT IS RECOMMENDED THAT TWO PERSONS ASSIST IN ASSEMBLY
Figure A. With a split pin inserted into the inner holes in each stub axle, place a flat washer, then a
wheel followed by another flat washer. Insert another split pin into the axle holes outside each flat
washer. Bend each side of the pins outward so they do not fall out.
PARTS DIAGRAM
Upper Drum
Lower Drum
Manual
Hardware
Support Braces
Wheel Brace
Frame Assembly
Motor
Cover
Support
Leg
Support
Arm
Wheels
Adjusting Plate