Use and Care Manual

MAINTENANCE
Disconnect the power supply before cleaning. Wear safety eyewear before cleaning. Use compressed dry air to blow off
dust and debris. Use a soft bristle brush if compressed air is not available.
Applying excessive force to the tool can overload the motor, decrease the life and increase the wear on the tool.
Some chemicals can damage the product. Do not use harsh chemicals such as gasoline, carbon tetracholiride, paint
thinner, etc.
A qualified repair technician must perform any tool service or repair. Service or maintenance performed by unqualified
personnel could result in injury. Use only identical replacement parts. Use of unauthorized parts or failure to follow maintenance
instructions may create a risk of electric shock or injury.
Do not make contact with a grounded surface while using this power tool. Contact with surfaces like pipes, radiators or major
appliances increases your risk of electric shock.
Keep construction debris out of grinder vents and triggers by blowing with compressed air.
Use only mild soap and a slightly damp cloth to clean the grinder.
This motor uses carbon brushes, which may require replacing. Carbon brushes wear out over time, and could create motor trouble. Keep
carbon brushes free and clear of debris, and replace worn parts when necessary.
ACCESSORIES
Use only accessories that are recommended by the manufacturer for your model. Accessories that may be suitable for one
tool may become hazardous when used on another tool.
Always attach grounded (3-prong) extension cords to grounded (3-prong) outlets.
If you must use an extension cord, be sure that the gauge is large enough to carry the amount of current necessary for
your power tool. If not, your tool may experience a loss of power, excessive voltage drop or overheating. The smaller the gauge
number, the heavier the cord.
PS072140909
PS07214 4 ½ Inch Angle Grinder Assembly & Operating Instructions
8