Service manual

2-10 IP-421 PRINT CONTROLLER

Chapter 2 Disassembly / Assembly

4. Mount the PS-341 on the print controller board.

Caution:

Position the PS-341 by matching the cut corner to that on the board.

PS-341

5. Fit the printer relay board into the connector of the IP-421 print controller.

Printer relay board

Fix the flash card stopper plate with two screws, then fix the printer relay board with three screws.

Printer relay board

Flash card

stopper plate

7. Fix the board cover on the IP-421. (11 screws)

8. To remove, reverse the installation procedure.

Caution:

To remove the PS-341, use a PCLL removing tool.

HOME