Manual
A;
c, Loosen the right side bevel stop lock nut.
:, ,.: : : . ....
Lower the bevel stop bolt: .down as faras it
will go, i ....... :i:_il j
d. Grasp the metal upper,,i_:g_rd !:Im_in and
:position the i_i_:_i:_:h_i'iUhtilthe blade
co,tactw th lengtho, the
square,
e. Tighten the bevel lock handle.
f, Use 10ram wrench end to hold the bevel stop
tock nut in place.
g. Use another wrench to turn the bevel stoD
bolt until it hits the bottom of the bevel stop.
h, Lock the bevel stop nut.
3, Check the bevel indicator. If indicator needs
adjustment use a phillips screwdriver and slide
the indicator to the 00 on the scale.
Bevel Sto
Bevel
Lock Nut
,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,, ,,,,,,,,,,,, , illlllll L Jill1
CHECKING AND ADJUSTING BLADE SQUARE
I, To check blade squareness to tence_ use a
combination square, Place the square against
the fence and next to the blade as illustrated,
Place the square so the set in the teeth won't
hold it from the blade. The blade should contact
the full length of the square=
2 If blade is not square to the fence, follow the
alignment procedure,
a, Loosen miter tock handle a half turn. ]-he
latch handle should still be secured witt7
blade in lowered position.
NOTE: Take the saw oft its stand, bench or
plywood base if readjustment is necessary.
CAUTION: To keep from losing control of the
unit, steady the base with one hand while
loosening the two bolts with the other hand,
b, With tt_e unit securely resting on a large
stable surface, tilt the unit by lifting up on
one side or the other of the base. Loosen the
two miter arm bolts on the underside of the
turn table with a 6rnm hex. "L" wrench. Tilt
the unit by lifting up on one side or the other
side of the base.
c, Return the saw to its normal resting position.
Make sure the miter lock handle is loose but
do not release the index spring.
d. Use the miter saw handle to turn the turn
table and saw so that the blade contacts the
full length of the square. Watch out for tooth
set. Turn the miter lock handle clockwise to
lock saw square to fence,
e. Tilt saw as in Step b and tighten bolts,
f. Recheck blade squareness to fence and
readjust it necessary.
Adjustment of Miter Scale Indicator
1 Loosen the phillips screws that hold the indi-
cator in place, Reposition the indicator and
retighten screw,
11