Manual

opposite end. Compound mi_rs:_;_re:_i_ky" to
make because the: m_i_S_etti_:_and 'bevel setting
are dir_ly_reiated t0 :each other, Every time the
miter Setting is changed the bevel setting must
also be adjusted, likewise every adjustment to
bevel requires a corresponding adjustment to
miter. Because it may take severat tries to obtain
the desired angle it is advisable to make test cuts
in a scrap piece of material.
TIPS FOR CUTTING COMPOUND MITERS
A compound miter is a cut requiring botha miter Miter i
setting and bevel setting. A compound miter is
used for making frames or boxes that hive sloping .............
sides and are wide at One end lnd. nari_Ow_ the Bevel
Setting
33,8 °
33.80
31.6 °
RIGHT
31.6 °
LEFT
TIPS FOR CUTTING CROWN MOLDING
Miter
Setting
Type of Cut
.33.8 ° 31.6_
LEFT
LEFT SIDE, INSIDE CORNER:
1.Position top of molding
against fence.
2.Left side is finished piece.
33.8o 31.6_
RIGHT
RIGHT SIDE, INSIDE CORNER:
1.Position bottom of molding
against fence,
2.Left side is finished piece.
LEFT SIDE, OUTSIDE CORNER:
1.Position bottom of molding
against fence.
2.Right side is finished piece.
RIGHT SIDE, OUTSIDE CORNER:
1.Position top of molding against
fence.
2.Right side is finished piece.
A compound miter saw !s excellent for cutting
crown molding. Crown molding is difficult to cut
because in order to fit correctly it must be
precisely mitered.
All Standard (U.S.) crown molding has a top rear
angle (fits next to ceiling) of 52° and a bottom rear
angle (fits against wall) of 380.
NOTE:On all above cuts lay molding with broad
back surface flat on table.
Pre-testing Compound Settings on Scrap Material
Is Extremely Important !
i,cornr
2O