Manual
Trouble Shooting
TROUBLE
Brake does not stop
blade within
2-5 seconds.
Motor does not start.
PROBLEM
1. Brushes not seated
or lightly sticking,
,
Angle of cut
not accurate.
Can't move
miter adjustment.
Motor brake winding-
overheated from use of not
recommended accessory
or rapid on/off cycling.
3. Arbor screw loose.
4. Other.
!, Fuse.
2. Brushes worn.
3. Other.
Brush sparking when !. Normal--automatic brake
switch released, working properly.
Blade hits table. 1, Misalignment, -See Assembly and Alignment.
2. Damaged depth stop. -Get authorized Service.
1. Misalignment. -See Assembly and Alignment.
1. Sawdust under table, --Vacuum or blow out dust,
WEAR EYE PROTECTION
Power-head
wobbles.
Power-head
won't fully rise.
Blade binds, jams,
burns wood.
Tool vibrates or
shakes.
1. Loose pivot points,
1. Pivot misadjustment,
2. Part tailure.
3. Pivot spring not replaced
..... properly alter service,
1. Improper operation.
2. Dull blade.
3. Improper blade.
4. Warped blade.
1. Saw blade not round.
2. Saw blade damaged.
3. Saw blade loose.
4. Other.
REMEDY
.... insp'_'"t!c'_'_nlrepla'_e_.,_= _. brushes ........
(see maintenance section).
-Use a recommended blade.
-- Let cool down.
- Retighten
-Authorized service. Check motor brake winding,
switch, condition of commutator,
- 15-Amp time delay luse, or CKT. breaker.
-- See =M ainten ance."
- Authorized service.
-See Assembly and Alignment,
- See Assembly and" Alignment,
-Get authorized Service.
- Get authorized Service.
-See Basic Saw Operation,
-Replace or sharpen blade.
--Replace with 10" diameter blade designed
for the material being cut.
- Replace blade.
- Replace blade.
-- Replace blade.
-Tighten arbor screw.
:_ ; --Get authorized Service.
27