Specifications
MOUNT THE MITER SAW
(Figures 33 - 38)
MOUNTING THE MITER SAW TO'THE BOARDS
Secure boards to frame of miter saw stand as explained in "ADD
MOUNTING BOARDS" on page 23. Loosen clamps slightly and position
boards to be slightly wider than the base of the miter saw to be mounted.
To square boards, align grid on boards with the frame of the miter saw
stand.
Position miter saw on boards with fence of saw in line with center of
clamps. Saw base should be approximately 1" from front edge of
boards and 1/2" from slot in boards. See Figure 34.
NOTE: Position saw and boards so mounting bolts will not interfere with
frame of miter saw stand.
Be sure to position your saw and boards for maximum
stability.
Using a pencil, mark saw base mounting holes on boards. Remove saw
and boards from stand and drill mounting holes using a 1/4" bit. Mount
saw to boards using screws (X), washers (Q), and hex nuts (Y). See
Figure 35.
Fig. 33
Q(8)
24