PR@® This manual covers the following models: » R2618 (Requires a Wired Sensor Capable Thermostat) Caution: Equipment damage hazard Do not operate the cooling system if the outdoor temperature is below 50° F (10° C) to prevent possible compressor damage. Pal ies Page Need Help? Mounting Locations Sensor Mounting & Setup .
MOUNTING LOCATIONS Emote Sensor Locations The remote sensor should be mounted or placed approximately 4 to 5 feet above the floor. Select an area with average temperature and good air circulation. YES Do not mount or place Remote Sensors in locations: « Close to hot or cold air ducts. + That are in direct sunlight. = With an outside wall behind the thermostat. # In areas that do not require conditioning. * Where there are dead spots or drafts {in corners or behind doors).
Wall Mount © Remove the cover of the R2515. 3) Mount sub base to the wall @ Inside View of Sub base of Remote Sensor Connecting to a Wired Sensor Capable Thermostat (1) Loosen the terminal block (2) Connect the R2518 to the S terminal screws. Insert wires, then re tighten terminal block screws. Mor Flammable b Insulation Terminal Blocks @ Place non-flammable insulation into wall openings to prevent drafts. blocks on the Wired Sensor Capable Thermostat.
LT Wiring You can connect F251S ramble sensors to a Wired Sensor Capable Thermostat to achieve a more accurate temperature average throughout a space. The following diagrams Illustrate the proper ways to wire the R2518 remote sensor. Use 18 AWG thermostat wire when installing. 1 R2518 4251ST ee —— SES saa 21H Rey BEES one] lie I [ Ba Pik Lm 4 Ross 16 R258 tr ot slE SH S| RISE we PRE FRE “2 PREY I 1 f PREY PRE PRE | 1 ! FRG FREY PRO bp] Specifications R2518 Wired Sensor ..
Contact Us Port IAQ Inc. 5. Glen stone Suite 2-100 Springfield, MO 65804 Toll-free: 1-888-Propitiate (776-1427) Toll Number (Outside the USA): 330-821-3600 Web: Hours of Operation: Monday Friday Eastern Warranty Registration; Your new Port wired sensor has a 5 bear limited warranty. You must register your warranty within 80 days of installation. You can register your new sensor in 2 ways. @ Go to www.protiag.com, select warranty registration and fill out a short registration form.