Pro1 Installation Manual

Caution:
Electrical Hazard
WIFI Setup
These WIFI Technician steps/
options used for information
and trouble-shooting. They are
not used for installation or initial
setup.
The only normal function you
would use this step for would be to
RESET WIFI provisioning. For
example: If you replaced your
home WIFI router and need to
connect via a dierent network.
Follow these steps to enter the
WIFI-technical information menu.
Follow these steps to enter the
WIFI-technical information menu.
1. Press and hold the + and - buttons
for 3 seconds.
2. Press WIFI button at lower right.
3. Top of display will show:
“WIFI NOTOK” if NOT connected
to WIFI. “WIFI OK” if connected to
WIFI.
4. IF NEXT button is pressed, top of
display will show:
The rmware and software
versions that are installed on the
thermostat. You can scroll through
them with the + and - buttons.
5. IF NEXT button is pressed again,
top of display will show:
The SSID # of the thermostat. if
NEXT is pressed again, you will
return to step 4.
1. Go through steps 1 and 2 from the
WIFI menu at left.
2. Press and hold the TECH button at
lower left for 3 seconds.
3. Top of display will show:
“RESET WIFI”
4. Press the YES button at lower left.
After a 5 second countdown, the
thermostat will reset.
Or press NO to exit