User Guide

Proaim Sr. Pan-Tilt Head with 12V Joysck Control 4
CABLES & CONTROL BOX
 Install the 12 volt DC power (4-pin XLR) in rear of
Joysck Box.
Note : Any 12 volt baery may operate the
PROAIM™ Sr. PAN TILT HEAD as long as the
connector mates and is #1 pin Negave and #4 pin
Posive.
CAUTION: DO NOT USE AN UNREGULATED POWER SUPPLY! IF USING A REGULATED POWER SUPPLY
IT MUST PRODUCE LESS THAN 12 VOLTS. MORE THAN 24 VOLTS MAY CAUSE PERMANENT DAMAGE.
JOYSTICK
 The joysck may be operated hand held, from a at surface like a table top or aached to the
boom arm of the jib.
HEAD CABLE
PROAIM™ Sr. PAN-TILT HEAD Digital only
 Aach the 4-pin power cord to the rear of Joysck
Box.
 Aach 4-pin male connectors of cable to the four
pin female connectors of head for panning & lng.
 If the Joysck Control is opposite, undo the
connectors at the motors, rotate 180 degrees and
re-install.