Instruction manual
Impulse 31
3
31 in (787mm)
9 in (229mm)
A3630-1800Kv Brushless
Programmable 80Amp
Brushless with Reverse;
Li-Po/Ni-MH switchable
Yes
Spektrum™ DX2E
2-Channel 2.4GHz Marine
Spektrum MR200
( 2) 7.4V 30C+
Li-Po with EC3™
connectors or (2)
7.2V Ni-MH with
EC3 connectors
Fiberglass
Composite
Deep-V
Offset with
Breakaway Rudder
Direct drive
flexshaft
4 AA batteries (sold separately) are
required to operate the transmitter.
• Needle nose pliers
• Paper towel
• Rubbing alcohol
• Open-end wrench: 10mm (2)
• Nut driver: 7mm
• Phillips screwdriver: #1
• Hex wrench: 2.5mm, 3mm
• Clear tape (PRB0102)
• Pro Boat
®
Marine Grease and Gun (PRB0100)
• (2) 7.4V 5200mAh Li-Po batteries (DYNP4000EC)
or (2) Speedpack™ 4500mAh Ni-MH batteries
(DYN1080EC)
• Passport™ AC/DC Li-Po battery charger
(DYN4066) or Prophet™ Sport
AC/DC Peak Ni-MH battery charger
(DYN4056)
Carefully remove the boat and radio transmitter from
the box. Inspect the boat for damage. If you find
damage is present, please contact the hobby
shop where you purchased your boat.
Pro Boat® RC models look as good as they perform. Our boats, which include everything from scale sailboats to
fully licensed powerboats, exceed expectations and provide years of radio control fun and excitement. Whether your
passion leads you towards the pure serenity of sailing or the all-out speed of a Deep-V, Pro Boat models fit your taste,
budget and lifestyle. You can count on us to be available any time you need help—the brand is backed by Horizon
Hobby, the world’s largest distributor of hobby-grade RC products. The Pro Boat brand will help you turn your boating
passion into a reality, whether you’re new to the hobby or an old pro.
Please read this manual for operation and maintenance instructions.
1. Attach the side stand pieces to the end pieces as
shown.
2. Use medium CA or epoxy adhesive to secure the side
stand pieces to the ends.
3. Allow the adhesive to dry before placing your boat on
the stand.