PRB07000 Ragazza ™ 1-meter ready-to-run sailboat Owners Manual Bedienungsanleitung Manuel de l'utilisateur Manuale dell'utente
EN NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, Inc. For up-to-date product literature, visit www.horizonhobby.com and click on the support tab for this product. WARNING: Read the ENTIRE instruction manual to become familiar with the features of the product before operating. Failure to operate the product correctly can result in damage to the product, personal property and cause serious injury.
EN Introduction Pro Boat® RC models look as good as they perform. Our boats, which include everything from scale sailboats to fully licensed powerboats, exceed expectations and provide years of radio control fun and excitement. Whether your passion leads you towards the pure serenity of sailing or the all-out speed of a Deep-V, Pro Boat models fit your taste, budget and lifestyle.
EN Transmitter Controls For more information on the transmitter, go to www.horizonhobby.com/products/SPMR2200 and click on the support tab for the Spektrum DX2M to download the instruction manual. Winch Trim Move the slider to change the winch trim. LEDs Battery Level Indicator Bind Button Steering Rate knob Push and hold to bind Steering rate limits the amount of travel of the steering servo. Winch Control Move the Winch Control UP on the transmitter to release the control lines.
EN Failsafe In the unlikely event that the radio link is lost during use, the receiver will drive the servos to their pre-programmed failsafe positions (normally sails out and straight steering). If the receiver is powered on before powering on the transmitter, the receiver will enter failsafe mode, driving the servos to their preset failsafe positions. When the transmitter is powered on, normal control is resumed. Failsafe servo positions are set during binding. Boat Assembly 1.
EN Mast and Sail Assembly 1. Slide the mast sections together on the wood block and secure the mast using the included screws. 1 2 2. Install the main boom and turnbuckle on the mast using 2 screws and 2 washers as shown. 3. Remove the mast crane from the top of the mast and slide the bottom of the main sail cord through the channel in the assembled mast. Replace the mast crane. 3 B A B 4. Secure the outermost corner of the main sail to the end of the boom using the nearby wire loop.
EN 7. Connect the snap hook on the front sail boom to the fitting on the hull (D). 7 8 8. Tie off the line at the top of the front sail through two holes in a stay, the hook in the front of the mast and the open hole of the stay, as shown. D 9. Insert the front and rear winch lines through fittings on the respective booms. Tie the rear line to the loop on the main boom as shown. Tie off the front line through the fitting near the middle of the front boom.
EN Getting Started 1 1. Power on the transmitter. 2. Connect the battery. 3. Power on the switch harness mounted under the deck hatch. 2 4. Test the transmitter’s control of the boat (out of water) as shown below. 5. Launch the boat into the water and start sailing. 3 Control Direction Test Perform a control direction test to see how quickly your sailboat responds to transmitter controls.
EN Adjusting Sails After you have centered the sails and the rudder, adjust the sails for the most fun and safe sailing. Briefly sail the boat to see how the sails need to be trimmed. Loosen or tighten a line at the cleat by coiling the line around the cleat. The DX2M transmitter included with your boat has a control by the sail stick to change between 50/50 and 70/30 travel. Adjust as desired, but always ensure you do not tighten the line too much and damage your boat.
EN When You are Finished 1. Power off the switch harness. 1 2 3 4 2. Disconnect the battery. 3. Power off the transmitter. 4. Remove the battery from the boat. 5. Loosen all lines. Always store the boat open (without the hatch sealed) or moisture may allow mold and mildew to grow in the boat.
EN Troubleshooting Guide Problem Boat does not respond to the transmitter Boat moves too fast or too slow for the wind and water conditions Boat tends to turn one direction Possible Cause Solution Boat receiver is not bound to the transmitter Bind the receiver to the transmitter Fouled or broken sails, lines or servo Replace/recharge batteries Ensure connections are secure and powered on Straighten, tighten or replace damaged parts Rigging may be worn Repair or replace damaged parts Sails may be
EN Limited Warranty What this Warranty Covers Horizon Hobby, Inc., (Horizon) warrants to the original purchaser that the product purchased (the "Product") will be free from defects in materials and workmanship at the date of purchase.
EN Non-Warranty Service Should your service not be covered by warranty, service will be completed and payment will be required without notification or estimate of the expense unless the expense exceeds 50% of the retail purchase cost By submitting the item for service you are agreeing to payment of the service without notification. Service estimates are available upon request. You must include this request with your item submitted for service.
EN FCC Information This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This product contains a radio transmitter with wireless technology which has been tested and found to be compliant with the applicable regulations governing a radio transmitter in the 2.400GHz to 2.
EN Compliance Information for the European Union AT ES LT RO BE FI LU SE BG FR LV SI CZ CY DE GR HU IE MT NL PL SK UK DK IT PT Declaration of Conformity (in accordance with ISO/IEC 17050-1) No. HH2013082901 Product(s): PRB Ragazza 1 Meter Sailboat RTR Item Number(s): PRB07000 Equipment class: 2 Instructions for Disposal of WEEE by Users in the European Union This product must not be disposed of with other waste.
IT Replacement Parts / Ersatzteile / Pièces de rechange / Pezzi di ricambio PRB270000 Mast, Boom (F&R) and Turnbuckle: Ragazza ProBoat Ragazza: Mast, Baum u. Spannwirbel ât, Bôme (Avant and M Arrière) et Ridoir Albero, boma (anter./ poster.) e tenditori PRB270001 Sail (F&R): Ragazza ProBoat Ragazza: Gross- u. Focksegel Voile (avant et arrière) Vele (anter./poster.
40164 Created: 08/2013 ©2013 Horizon Hobby, Inc. Pro Boat, the Pro Boat logo, Ragazza, Dynamite, DSM and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, Inc. The Spektrum trademark is used with permission of Bachmann Industries, Inc.
