Installation Guide

7
PROBRITE.COM
Please call 1-844-507-5651 or email [e-mail] for further assistance.
6
Visit www.probrite.com/install for installation video tutorials and product support
Installation (continued)
3
Remove the
mounting plate
B
CC
C
NOTE: The mounting plate (C) comes pre-as-
sembled on the light fixture (A) for shipping.
NOTE: The mounting plate tightening bolt (B)
comes pre-installed on the light fixture.
4
Installing the
mounting plate
AA
C
Installation (continued)
5
Hang fixture to
mounting plate
6
Making the electrical
connections
TIP: Ensure the light fixture (A) can safely hang
onto the mounting plate (D) to allow for use
of two hands to make the wiring connections
(fig 2).
A
A
D
D
C
C
C
A
D
BB
(fig 1).
(fig 2).
TIP: Only unscrew the tightening bolt (C) far
enough to remove the mounting plate (D). Do
not fully remove the tightening bolt (C).
LIGHTING
FIXTURE
(+) LINE
(-) COMMON
GROUND
BLACK
WHITE
GREEN
☐ Route the junction box wires through
the large center hole in the mounting
plate (C).
☐ Align the holes on the mounting bracket
(C) with the holes on your junction box.
Use two #8 screws (AA), depending
on the size of the holes in your junction
box, attach the mounting bracket (C) to
your junction box
☐ Please make sure, the "TOP" arrow is
pointing upwards.
☐ Place the small sphere head of the
hanger wire (D) between the back of
the small grove located on the bottom
of the center hole of the mounting plate
(C).
☐ Remove the mounting plate (C) from
the back of the fixture by loosening
the mounting plate tightening bolt (B)
using the allen key (CC).
☐ If necessary, strip 3/8" of insulation
from junction box or fixture (A) wires
(fig 1).
☐ Connect fixture black wire to house
black wire, the (+) line, and fixture
white wire to house white wire, the (-)
common by twisting the exposed wires
together and using the wire nuts (BB).
Ensure no loose wires.
☐ Connect house ground wire to the
green fixture ground wire, by twisting
the exposed wires together and using
the wire nuts (BB).
TIP: Hold stripped ends near each other and
align any frayed strands (do not twist wires).
Push the wires into wire nut (BB) and use your
fingers to twist the wire nut clockwise until tight.
Check for tightness by pulling wires.