Installation Guide

3
PROBRITE.COM
Please call 1-844-507-5651 or email [e-mail] for further assistance.
2
Visit www.probrite.com/install for installation video tutorials and product support
Table of Contents..................... 2
Safety Information.................... 2
Pre-Installation.......................... 3
Planning Installation.................. 3
Specifications.............................. 3
Tools Required............................. 3
Hardware Included..................... 4
Package Contents..................... 4
Installation.................................. 5
Care & Cleaning......................... 9
Troubleshooting........................ 9
Warranty..................................... 10
Table of Contents
Safety Information
IMPORTANT
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
NATIONAL ELECTRICAL CODE AND LOCAL BUILDING CODES BY A PERSON FAMILIAR
WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS
INVOLVED.
PRECAUTIONS
☐ Please read and understand this
entire manual before attempting to
assemble, install, or operate this light
fixture.
☐ This light fixture requires a 120-Volt
AC power source.
☐ Some codes require installation by a
qualified electrician.
☐ This light fixture must be properly
grounded.
☐ Make sure connections are secure
using wire nuts, crimp-on lugs or other
approved connecting devices
☐ This light fixture should be installed
outdoors to a wall or eave.
☐ This product may contain chemicals
known to be hazardous. Thoroughly
wash hands after installing, handling,
cleaning or otherwise touching the
product.
INFORMATION: The device is tested and found to comply with Part 15 of the FCC Rules. Operation is subject
to two conditions: (1) This device may not cause harmful interference and, (2) this device must accept any
interference received, including any interference that may cause undesired operation.
These limits are designed to provide reasonable protections against harmful interference when the equip-
ment is operated in a commercial environment.
WARNING: Turn the power o at the circuit
breaker or fuse. Place tape over the circuit
breaker switch and verify power is o at the light
fixture.
WARNING: Risk of fire. Keep the lamp heads at
least 3 in. (76mm) from combustible materials.
CAUTION: Burn hazard. Allow the light fixture to
cool before touching.
NOTICE: Do not connect this fixture to a dimmer
switch.
Pre-Installation
PLANNING INSTALLATION
Before installing the light fixture, ensure that all parts are present. Compare parts with the
Hardware Included and Package Contents sections. If any part is missing or damaged, do
not attempt to assemble, install, or operate this light fixture.
Estimated installation time: 20 minutes
MODEL SOL 12W SOL 20W
Lumens (Light Output)
900 Lumens 1600 Lumens
Watts (Power Consumption)
12 Watts LED 20 Watts LED
Replaces
75 Watt Bulbs 150 Watt Bulbs
Lumens/Watts (Efficacy)
75 lumens per watt 80 lumens per watt
Power Requirements (Input Voltage)
120VAC, 60 Hz
Light Color (CCT)
3000 Kelvins (Warm White)
Dimmable
Non-Dimming (Do not wire to dimming switch)
Operating Modes
Switch-Activated:
Flip switch to turn light fixture ON and OFF.
Use external photocell light sensor, timer or
motion sensor for automatic functionality
(sold separately)
SPECIFICATIONS
TOOLS REQUIRED
Phillips
Screwdriver
Wire strippers/
cutters
Circuit tester
Safety
goggles
Work
gloves
Silicone
Sealant
Ladder
NOTICE: FCC Regulations state that any
unauthorized changes or modifications to this
equipment not expressly approved by the man-
ufacturer could void the user’s authorization to
operate this equipment.