Installation Guide

5
PROBRITE.COM
Please call 1-844-507-5651 or email [e-mail] for further assistance.
4
Visit www.probrite.com/install for installation video tutorials and product support
Pre-Installation (continued)
HARDWARE KIT
NOTE: Hardware not shown to actual size.
AA
E
Part Description Quantity
AA
#8-32 x 3/4" philips mounting bracket screw 2
PACKAGE CONTENTS
Part Description Quantity
A
Light fixture 1
B
Conduit entry plug 1
C
Back plate housing tightening screw (pre-installed) 1
D
Back plate housing 1
E
Wago quick wire connectors
(pre-installed in fixture back box)
3
F
Leveling bubble 1
Installation
1
For best results
Wall Mount
1/2" 1/2"
Round
Octagonal /
B
A
C
D
NOTE: Mounting base (D) mounts to recessed
mounted standard junction boxes or to the
surface directly. Junction box must be at least
1/2 inch in depth for proper installation for
recessed mount application (fig 1).
(fig 1).
2
Shut electric power off
☐ At wall switch verify it is in the o
position (fig 1).
☐ At the main electrical panel turn o
the circuit breaker that supplies power
to the outlet box you are working on
(fig 2).
☐ For screw-in type fuses unscrew the
fuse that supplies power to the outlet
box you are working on (fig 3).
(fig 1).
(fig 2).
(fig 3).
☐ The fixture can be mounted in the
following two ways:
☐ Junction Box Mount: Use an
external junction box to mount the
fixture.
☐ Surface Conduit Mount: The fixture
can also be mounted directly on the
wall surface using conduit entry.
☐ When installing two fixtures on one
switch, make sure the switch is rated
for at least a 1A inductive load.
☐ Do NOT wire to a dimming switch.
F