Installation Guide

7
PROBRITE.COM
Please call 1-844-507-5651 or email [e-mail] for further assistance.
6
Visit www.probrite.com/install for installation video tutorials and product support
Installation (continued)
3
Remove the back housing
mounting base
C
D
NOTE: The back plate housing tightening
screw (C) comes pre-installed on the light
☐ Remove the mounting base (D) from
the bottom of the fixture by loosening
the mounting base tightening screw
(C) using a philips screwdriver.
4
5
Knock out holes on
mounting base
Installing the mounting base
Installation (continued)
6
Making the electrical
connections
D
D
E
BB
D
(fig 1).
(fig 2).
Junction box Mount
Junction box Mount
Surface Conduit Mount
Surface Conduit Mount
☐ Route the junction box wires through
the large center hole in the mounting
base (D).
☐ Align the holes on the mounting
base (D) with the holes on your
junction box. Use two #8 screws (AA),
depending on the size of the holes in
your junction box, attach the mounting
base (D) to your junction box. (Fig. 2)
☐ For handsfree operation, to allow both
hands to make electrical connections,
use the hinge on the mounting base to
hang the fixture. (Fig 1).
☐ Follow the wiring instructions
given below to make the electrical
connections. (Fig 1)
☐ For handsfree operation, use the hinge
on the mounting base to hang the
fixture.
☐ Remove one conduit plug from the side
of the fixture from the where conduit
will enter. (Fig. 2)
☐ Make wiring connections inside the
fixture as per the instructions given
below.
☐ Mark and drill two holes on the
wall surface as per the desired
location for fixing the mounting
plate (D).
☐ Use two or more suitable screws
(provided by others) applicable
to the mounting surface and fix
the cast junction box (B) on the
surface. (Fig. 2)
Junction box Mount
Surface Conduit Mount
☐ Refer to the guide in Fig. 1a to select
the holes to knock out or measure your
junction mounting holes and determing
proper knock-outs on the fixture's back
housing.
☐ Use a flat head screw driver and
hammer to knock out two holes in
the mounting base (D) in the desired
location to align properly with the
junction box. (Fig. 1b)
Conduit
(fig 1b).
(fig 1a).
Place fixture
on top of back
housing for
hands-free-install
TIP: Use the leveling bubble (F) inside the back
housing to adjust mounting for a level install.
F
Screws
(Provided by
others)