Installation Guide

9
PROBRITE.COM
Please call 1-844-507-5651 or email [e-mail] for further assistance.
8
Visit www.probrite.com/install for installation video tutorials and product support
D
Installation (continued)
Installation (continued)
7
Mounting the light
fixture
7
Caulking around the
light fixture
NOTICE: Failure to properly caulk around the
surface and mounting plate (D) could lead
to water damage and is not covered under
warranty.
NOTE: When attaching this fixture (A) to an
external, surface mount junction box, caulk the
inside of the light fixture before attaching to the
mounting plate (D).
(fig 1).
☐ Caulk around the mounting plate (D)
and surface with silicone sealant (not
included).
Care and Cleaning
☐ Shut o main power supply before cleaning the product. To prolong the original ap-
pearance, clean the light fixture with clear water and a soft, damp cloth only.
☐ Do not use abrasive cleaners or cleaners that contain alcohol. Do not apply paints,
solvents, or any other chemicals on this light fixture. They could cause a premature
deterioration of the finish and may void the warranty.
☐ Do not spray the light fixture with a hose or power washer.
LIGHTING
FIXTURE
(+) LINE
(-) COMMON
GROUND
BLACK
WHITE
GREEN
Wiring Instructions
☐ If necessary, strip 3/8" of insulation from
junction box or fixture (A) wires (fig 1).
ON/OFF Wiring Method:
☐ Connect fixture black wire to house black
wire, the (+) line, and fixture white wire
to house white wire, the (-) common by
inserting the exposed house wires into the
corresponding wago connector (E). Ensure no
loose wires.
☐ Connect house ground wire to the green
fixture ground wire, by inserting the exposed
house wires into the corresponding wago
connector (E). Ensure no loose wires.
☐ Close the fixture by tightening the
mounting base tightening screw (C),
using a philips screwdriver, which was
removed earlier in Step 1. (Fig. 1)
C
D
(fig 1).
If Light does not come on:
☐ Verify that the power is turned ON from the circuit breaker and wall switch.
☐ Verify the wiring for the fixture is done properly.
☐ Verify the line voltage is correct.
If Light flickers:
☐ Do not wire to a dimming switch, use a standard ON/OFF switch
Troubleshooting
Wago Connectors:
Open tab,
place wire into
corresponding
hole, and close tap