Specifications

AMP2-T assembly instructions. © 41Hz Audio / www.41hz.com Revision 1.0T boards
Most Zn-PB solder will melt at around 180ºC. The TP2350B chip is tested for soldering for 10
seconds in 260ºC so you have some margin. Subjecting the chip to high temperatures for a
prolonged time may damage the chip.
The TC2001 chip does not have a heat slug and does not require a heat sink.
APPENDIX 4: Connector pinouts
• Mute jumper; close to awake the amp
• The V5-agnd must be well stabilized / filtered. Voltages above 5.5V will damage the
Tripath chipset
• In1 and In2 should be grounded as indicated, not elsewhere. Input signals above +/- 2.5V
can damage the TC2001 chip.