User guide

821116: AMP2-16V Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
121
Chapter 5 Menu List
Preset Management Menu
Figure 5–28 Preset Management Menu
• Copy From: Rotating this knob steps through source presets for the
copy. Press the knob to copy the preset shown. This knob is to be
used in conjunction with the Copy To knob. Pressing either one will
copy the indicated preset.
• Save Current Config: Press the knob to display the Preset Label
Menu
and save the current settings into the selected preset.
• Rename Preset: Rotating this knob allows you to select from any of
the presets. Pressing this knob displays the Label Menu where you
can enter a new name for the preset.
• Clear Preset: Rotating this knob selects a preset to be cleared, and
pressing the knob clears it. A warning appears to verify that this
action was intentional. Pressing the knob a second time will clear
the preset completely.
• Copy To: Rotating this knob selects the destination preset for the
copy. Pressing the knob completes the copy. This knob is to be used
in conjunction with the Copy From Knob. Pressing either one will
copy the indicated preset.
• Recall on Power Up: Rotating this knob allows you to select from
any of the presets, or the last known state of the unit. Thus, after a
power failure, or after the unit is unplugged and then subsequently
powered up, the unit can either start up in its last known state, or in
the selected preset.
Preset Management Menu
Save / ExitHelp Cancel
Preset 4:
User Preset 4
Preset 1:
User Preset 1
Preset 1:
User Preset 1
Current Config
Current Settings
Preset 1:
User Preset 1
Preset 4:
User Preset 4
Clear
Preset
Rename
Preset
Save
Current
Config
Copy
From
Copy To
Recall
On
Powerup
Note:
None of the preset modifications are saved until the
Save/Exit button is pressed. All changes are cancelled
if the
Cancel button is pressed