User guide

821116: AMP2-16V Series User Guide

Chapter 2 Installation

FCC Compliance

Power

The unit comes with one 100 - 240 VAC +/- 10%, 150W, 50/60Hz

power supply module. A second identical module is an optional

accessory for use when redundancy is necessary. These modules plug

in to the back panel and are secured with thumbscrews. The power to

each supply connects an A/C mains power source through the IEC

connector provided on the back panel of each power supply.

When the mains plug or appliance coupler is used as the disconnect

device, the disconnect device should remain operable.

FCC Compliance

This equipment has been tested and found to comply with the limits for

a Class A digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is

likely to cause harmful interference in which case the user will be

required to correct the interference at his own expense.

Rear Panel Connectors

Standard Connectors

The AMP2-16V Series monitor back panel contains all of the connectors

except for the headphone jack as shown in Figure 2–1 on page 22. Note

that, as you are facing the rear panel, the audio module slots are

numbered from right to left.