Specifications

24
• Increase or decrease the head-to-head distance between the
two remote controls, within a 1 to 5 inch range.
• Increase or decrease the time you press-and-hold the button on
the original remote control in step 5, for 1 to 2 seconds.
• Avoid fluorescent lights or strong sunlight during the set-up.
These lighting conditions can cause interference with the
learning process.
• Verify that the original remote control contains fresh batteries.
Some remote controls operate at non-standard IR, UHF or ultrasonic frequencies,
and are unable to be learned. If you continue to experience difficulty during
set-up, please contact authorized dealer for assistance.
learning new functions
on device buttons
The eight Device buttons at the top of the remote control can also learn new
functions. These buttons can only be set up in the Audio mode. If a new func-
tion is learned on a Device button, the new function will override any existing
preprogrammed information on the Device button.
1 Place the PRE remote and the original remote control to be
learned from, on a flat surface. Line up the remote controls
head-to-head, about two to three inches apart.
2 Press-and-hold both the audio and play buttons simultaneously,
for about three seconds, until the LCD on the PRE remote
shows LEARN. The PRE remote is now in the learning mode.
NOTE: Each of the following steps must be completed within 20 seconds. If the
remote does not receive any commands within the allotted time, it will return
to its normal operating mode.
3 Press-and-release one of the eight Device buttons on the PRE
remote. The LCD will show READY.
4 Press-and-hold the button on the original remote control you
wish to teach into the PRE remote, for about three seconds.
The LCD on the PRE remote will show – – – – indicating that it
is receiving the information from the original remote control.
5 Release the button on the original remote control. The LCD
on the PRE remote will show RETRY.
6 Press-and-hold the same button on the original remote again,
for about three seconds. The LCD on the PRE remote will
flash GOOD, the Device Mode and then return to LEARN,
verifying that the new function has been learned.
Repeat Steps 3 through 6 for any other buttons you wish to learn new
functions.
7 Once you have completed the learning for all the desired
Device buttons, store the learned functions by pressing the
audio and play buttons simultaneously, once again. The LCD
in the PRE remote will show SAVED and then return to the
AUDIO mode. The remote has now returned to the original
operating mode.