Specifications

Notice that a yellow LED in the main display lights up briefly

after you press mute. This LED indicates that the PRE is trans-

mitting the command which corresponds to the code you

have selected. You may repeat the process of selecting special

commands (using volume +/–) and then transmitting them

(pressing mute) until all desired commands have been

learned by your remote control.

5 Repeat the process of “teaching” new commands to the various

buttons on the PRE remote control until all desired commands

have been learned by the remote control.

If you take longer than approximately ten seconds between

front panel button pushes, the PRE will time out and return

to “0L” status, and subsequently to normal operation. If this

occurs, return to step #1 in this section. (You should test all

your new “learned” commands to ensure that they were

“learned” correctly.)

6 When finished, exit the special programming mode by pressing

the standby button again. This action will return you to the nor-

mal “0L” front panel button level of programming. You could, of

course, also wait for the PRE to “time out” and return to this

mode after about ten seconds.

7 Return to normal operation by pressing and holding the

balance button until the display reverts to normal. Alternatively,

you could simply allow the PRE to “time-out” again. The two

time-outs required to work your way backwards from the spe-

cial programming mode to normal operation would, together,

take approximately twenty seconds. You can hurry things along

(if you wish) by using the balance button as described.