Operating instructions

ManualsBrandsProchem ManualsAutomotive100A

MAINTENANCE

980076 08/26/03 4-11

DO NOT service this unit

while it is running. The high-

speed mechanical parts as well as high

temperature components may result in severe

injury, severed limbs, or fatality.

The following general instructions are for the repair

of various components. ONLY FULLY TRAINED

personal should repair components.

GASOLINE ENGINE

Refer to the Operation and Maintenance MANUAL.

If more detail is needed, you should procure a

Service and Repair book from your local authorized

Briggs and Stratton Service center.

VACUUM PUMP

Refer to the Vacuum Pump Maintenance Manual.

WATER PUMP

Refer to the Pump Maintenance Manual.

BURNER FUEL PUMP

The fuel oil pump, when applied correctly, will

require no repair; however, if in the course of normal

maintenance, you have a very dirty inlet filter,

proceed as follows:

1. Remove fuel pump cover.

2. Remove the strainer and clean with a brush

using clean kerosene.

3. Re-assemble the pump.

BURNER BEARING

The burner bearing on your unit may be removed if

defective. Proceed as follows after removing the

impeller and pulley from the shaft.

1. Remove the internal snap rings on each end of

bearing.

2. Using an arbor press and pressing down on the

cone side, press out the bearing.

3. Replace the snap ring on the cone end.

CAUTION: When replacing this bearing, always

press on the outside race of the bearing.

PRESSURE ON THE SHAFT WILL RUIN THE

BEARING.

4. Press the new bearing into the plate coupling

until it reaches the snap ring on the cone end.

5. Re-install the internal snap ring on the plate

side.

BURNER IMPELLER

The burner impeller; may be changed. After the

burner bearing and plate have been removed,

proceed as follows:

1. Clamp the burner pulley in a vise.

CAUTION: DO NOT CLAMP THE PLATE, as

the seals in the bearing will be damaged when

changing the impeller.

2. Remove the flexible coupling end, and the

external snap ring inside the impeller.

3. Loosen the set screw on the impeller hub, the

impeller may now be removed.

4. Reassemble with new impeller.