Installation Guide

www.usaprocom.com
3200498-01A
SIZING THE FIREPLACE HOOD TO THE FIREPLACE OPENING OR
GLASS DOOR FRAME
ASSEMBLY INSTRUCTIONS
The replace hood assembly is adjustable
from 28" to 48". The hood assembly must
be opened wide enough to cover the entire
replace opening. The hood can be opened
wider if desired. Fore best appearance, make
sure center section of the hood assembly is
centered with the replace opening. Follow
the instructions below to properly size the
replace hood assembly.
1. Measure width of replace opening or
glass door frame (see Figure 1). Use
work space below to gure proper size
for replace hood.
Measurement "A"__________________
Subtract 24"
(width or hood center section) _________
Subtotal = _______________________
Divide by 2 ______________________
Measurement "B"__________________
Measurement "B" is the distance from
the outside edges of the adjustable
outer-hood assembly sections (see Fig-
ure 2). When adjustable outer sections
are extended to this measurement, hood
assembly will be correct size. The overall
width of the hood assembly will equal
the width of the replace opening. If you
have glass doors and would like the hood
assembly to hang beyond the edge of the
door frame, add 1/2" to measurement "B".
Make sure that the hood provides room
for opening doors.
2. Place center-hood section face down on
a smooth, soft surface.
3. Measure in from the outside ends of the
adjustable outer-hood sections. Place a
piece of tape on the bent-under ange
of the adjustable outer-hood sections to
mark the distance of measurement "B"
(see Figure 3).
4. Slide the adjustable outer-hood sections
into center section. Stop when the edge
of the center-hood section is even with the
tape (see Figure 4). Place pieces of tape
across adjustable outer-hood sections
and center-hood section to hold in place.
IMPORTANT: Tape must be removed before
operating the replace.
Measurement ”A”
Fireplace Opening
Measurement ”A”
Glass Door Frame
Measurement ”B”
Adjustable Outer-Hood
Sections
Center-Hood
Section
Figure 2
Figure 3
Figure 4
Figure 1
Tape
Adjustable Outer-
Hood Sections
Measurement ”B”
Edge of Center-
Hood Section