Installation Guide

www.usaprocom.com
5200498-01A
ASSEMBLY INSTRUCTIONS
Figure 9
Figure 10
Figure 11
BB
E
Lintel
E
A
BB
4. Slide replace hood assembly (A) over
mounting brackets (E). See Figure 10.
3. Use the 4 masonry screws (BB) provided
to fasten the brackets to the lintel (see
Figure 9).
INSTALLING HOOD TO MANUFACTURED FIREPLACE
WARNING: Many manufac-
tured fireplaces have louver
openings for ventilation. Do not
cover any louver openings with
replace hood. Do not mount
replace hood above any louver
openings. Only mount replace
hood below louver openings.
Covering louver openings or
mounting replace hood above
louver openings will cause the
replace to overheat and could
cause property damage, per-
sonal injury, or death due to re.
You may need to alter or discard the mounting
brackets to install the replace hood to the
manufactured replace.
Installing Above Manufactured
Fireplace Opening
1. Cut mounting bracket off at point "X" (see
Figure 6, page 4).
2. Tape mounting bracket (E) to replace
housing. Make sure top of mounting
bracket is 6" above replace opening (see
Figure 11).
3. Mark screw locations through slots in
mounting bracket (E).
4. Remove mounting bracket (E) and drill a
1/8" diameter hole into replace housing
at each marked location.
5. Use the 4 metal screws (AA) provided to
fasten brackets to replace housing (see
Figure 11).
6. Slide replace hood assembly (A) over
mounting brackets (E) (see Figure 11).
IMPORTANT: Tape must be removed before
operating the replace.
E
6"
AA
A
Manufactured
Fireplace
Fireplace Opening
IMPORTANT: Tape must be removed before
operating the replace.