Installation Guide

INSTALLING LOGS (WAN18-2 & WAN24-2)

Provided Logs: 8

1. Firstly put vermiculite into burn

pan.

Then pulling glowing em

ber loosely,

and sprinkle uniformly the surface of

vermiculite. And insert log #1 into slots

in rear log bracket on grate base.

5. Insert log #5 on log #1 and log #2.

Place

log #6-1, 6-2, 6-3 in front.

4. Insert log #4 on log #1 and log #2.

3. Insert #3 on log #1 and log #2.2. Insert log #2 into slots in middle

grate bracket.

CAUTION: After installation and periodically thereafter,

check to ensure that no yellow ame comes in contact with

any log. With the heater set to High, check to see if yellow

ames contact any log. If so, reposition logs according to

the log installation instructions in this manual. Yellow ames

contacting logs will create soot.It is very important to install

the logs exactly as instructed. Do not modify logs. Use only

logs supplied with heater.

Each log is marked with a number. This number will help you

to identify the logs when installing. After installing logs, add

decorative cinders around the grate base, do not place any

decorative cinders on logs or burner.

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specically approved

with this heater may result in property damage or personal injury.

Vermiculite and Glowing Ember