Installation Guide
www.usaprocom.com
19200068-01A
OPERATION
WARNING: If you do not fol-
low these instructions exactly,
a re or explosion may result
causing property damage, per-
sonal injury or loss of life.
A. This appliance has a pilot which must
be lighted by hand. When lighting the
pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the oor because some
gas is heavier than air and will settle
on the oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
• If you cannot reach your gas supplier,
call the re department.
C. Use only your hand to push in or turn
the gas control knob. Never use tools.
If the knob will not push in or turn
by hand, don’t try to repair it, call a
qualied service technician. Force or
attempted repair may result in a re or
explosion.
D. Do not use this appliance if any part
has been under water. Immediately call
a qualied service technician to inspect
the appliance and to replace any part of
the control system and any gas control
which has been under water.
FOR YOUR SAFETY READ BEFORE LIGHTING
Avoid any drafts that alter burner ame
patterns. Do not allow fans to blow directly
into the replace. Do not place a blower inside
the burn area of the rebox. Ceiling fans may
create drafts that alter ame patterns. Sooting
and improper burning will result.
During manufacturing, fabricating and ship-
ping, various components of this appliance
are treated with certain oils, lms or bonding
agents. These chemicals are not harmful but
may produce annoying smoke and smells as
they are burned off during the initial operation
of the appliance, possibly causing headaches
or eye or lung irritation. This is a normal and
temporary occurrence.
The initial break-in operation should last four
to six hours with the burner at the highest
setting. Provide maximum ventilation by
opening windows or doors to allow odors to
dissipate. Any odors remaining after this initial
break-in will be slight and will disappear with
continued use.
This appliance must not be used with glass
doors in the closed position. This can lead
to pilot outages and severe sooting outside
the replace.
Always operate heater with glass doors fully
open.
INSTALLATION
5. Place log #5 on the top of log #1 and log
#2, inserting pin in log #1 into the hole in
the bottom of log #5 (see Figure 27).
6. Place log #6 on the top of log #1 and log
#3, inserting pin in log #1 into the hole in
the bottom of log #6. Be sure the opposite
end of log #6 aligns with the recess in log
#3 (see Figure 27).
7. Add lava rocks around the grate base of
heater. Do not place any lava rocks on
logs or burner.
Log #5
Log #6
Figure 27 - Installing Logs #5 and #6
(WZL30MVA Shown)