Product specifications

16
INSTALLING LOGS
Fig. 14 - Installing Log Set
IMPORTANT: Make sure log does not cover any burner ports (see
Fig. 14). It is very important to install the logs exactly as instructed.
Do not modify logs. Use only logs supplied with heater.
STEP 1: Install log 1 onto the two slots in the rear
rebox panel.
All logs
STEP 2: Install log 2 onto the two slots in middle plate.
STEP 4: Insert the recessed hole on the bottom of
log 4 onto the pin on log1, with the other
end of log 4 placed on log 2, as shown.
STEP 5: Insert the recessed hole on the bottom of log 5 onto
the pin on log 2, with the other end of log 5 placed
on log 3, as shown.
1 2
3 5 4
WARNING: Failure to position the parts in accordance with
these diagrams or failure to use only parts specically approved
with this heater may result in property damage or personal
injury.
CAUTION: After installation, and periodically thereafter,
check to ensure that no ame comes in contact with any log.
With the heater set to high, check to see if ames contact
any log. If so, reposition logs according to the log installation
instructions in this manual. Flames contacting logs will
create soot.
STEP 3: Install log 3 onto the two slots in front plate.
Fig. 13 - Installing Mid Log Bracket
Locate Mid Log Bracket and screws in hardware package. Attach
bracket in burner pan with two screws. (See Figure 13)