Product specifications

19
INSPECTING BURNERS
Check pilot ame pattern and burner ame patterns often.
PILOT FLAME PATTERN
1. Turn control knob to pilot position
2. Inspect pilot ame and refer to Fig. 16 and 17.
• Fig. 16 shows a correct pilot ame pattern.
• Fig. 17 shows an incorrect pilot ame pattern. The incorrect pilot ame is not touching the thermocouple. This will cause the
thermocouple to cool. When the thermocouple cools, the heater will shut down.
• If the pilot ame is incorrect, as shown in Fig. 17, turn heater off (see “To Turn Off Gas to Appliance, " page 18). See
Troubleshooting, page 21 - 22.
Fig. 18 - Correct Pilot Flame Pattern with Control Knob
Set to High Flame (5)
Fig. 19 - Incorrect Pilot Flame Pattern with Control
Knob Set to High Flame (5)
BURNER FLAME PATTERN
Fig. 18 shows a correct burner ame pattern. Fig. 19 shows an incorrect burner ame pattern.
• If burner ame is incorrect, as shown in Fig. 19, turn heater off (see “To Turn Off Gas to Appliance”, page 18).
• see Troubleshooting, pages 21 through 22.
BURNER PRIMARY AIR HOLES
Air is drawn into the burner through the holes in the tting at the entrance to the burner. These holes may become blocked with
dust or lint. Periodically inspect these holes for any blockage and clean as necessary. Blocked air holes will create soot.
Fig. 16 - Correct Pilot Flame Pattern Fig. 17- Incorrect Pilot Flame Pattern
More than 8 in above top of logs
Approx. 3-6 in above top of logs