Use and Care Manual

INSPECTING BURNERS

Check pilot ame pattern and burner ame patterns often.

PILOT FLAME PATTERN

1. Turn control knob to pilot position

2. Inspect pilot ame and refer to Fig. 20 and 21.

• Fig. 20 shows a correct pilot ame pattern.

• Fig. 21 shows an incorrect pilot ame pattern. The incorrect pilot ame is not touching the thermocouple. This will cause the

thermocouple to cool. When the thermocouple cools, the heater will shut down.

• If the pilot ame is incorrect, as shown in Fig. 21, turn heater off (see “To Turn Off Gas to Appliance,” page 19). See

Troubleshooting, page 22 - 23.

Fig. 20 - Correct Pilot Flame Pattern

Fig. 22 - Correct Pilot Flame Pattern with

Control Knob Set to High Flame (5)

Fig. 23 - Incorrect Pilot Flame Pattern with Control

Knob Set to High Flame (5)

Fig. 21- Incorrect Pilot Flame Pattern

BURNER FLAME PATTERN

Fig. 22 shows a correct burner ame pattern. Fig. 23 shows an incorrect burner ame pattern.

• If burner ame is incorrect, as shown in Fig. 23, turn heater off (see “To Turn Off Gas to Appliance”, page 19).

• see Troubleshooting, pages 22 through 23.

BURNER PRIMARY AIR HOLES

Air is drawn into the burner through the holes in the tting at the entrance to the burner. These holes may become blocked with

dust or lint. Periodically inspect these holes for any blockage and clean as necessary. Blocked air holes will create soot.

More than 8 in above top of logs

Approx. 3-6 in above top of logs