Installation manual
www.usaprocom.com
11200020-01A
NG
LP
Left Side of HeaterBack of Heater
NG
LP
Gas Inlet
Gas esté
NG
LP
Back Side of Heater
INSTALLATION
GAS SELECTION
This appliance is factory 
preset for propane/LP gas. 
No changes are required for 
connecting to propane/LP.
Only  a qualified installer  or 
service technician can perform 
gas selection and connecting to 
gas supply.
 CAUTION: Two  gas  line  in-
stallations at the same time are 
prohibited. The  access plate 
to the simple switching means 
shall  not  be  opened  while  the 
heater is in operation.
  CAUTION:  To  avoid  gas 
leakage at the inlet of regulator, 
a  qualied  installer  or  service 
technician must  use supplied 
hex plug with sealant.
 WARNING: Do not attempt to 
access or change the setting of 
the fuel selection means.
Access to and adjustment of the fuel selection 
means must only be performed by a qualied 
service person when connecting this appliance to 
a specied fuel supply at the time of installation.
Change of the selector setting to other than 
the fuel type specied at the time of installa-
tion could damage this appliance and render 
it inoperable.
The installer shall replace the access cover 
before completing the installation and operat-
ing this appliance.
For changing from propane to 
natural gas supply:
1.  Remove bottom screw from cover plate 
located on back side of heater (see Figure 
4). Rotate to expose fuel selection device.
2.  For NATURAL GAS, press in knob using 
a at screwdriver with a blade with thick-
ness of a quarter and turn knob clockwise 
  until  the  knob  locks  into  the NG 
position  (see  Figure  5).  Fuel  selection 
device must be locked in the NG position. 
Do  not  operate  heater  between  locked 
positions!
3.  Rotate and close cover over fuel selection 
device and reinstall screws.
4.  Remove hex plug (with wrench provided) 
from  natural  gas  inlet  of  regulator  (see 
Figure 5). Install gas line into NG inlet of 
regulator.  Use  thread  sealant  to  assure 
there are no leaks.
Figure 4 - Gas Control Locations
Figure 5 - Settings for Natural Gas 
Selection
Cover Plate for 
Fuel Selection 
Device
Gas Regulator 
Inlet Connections
Fuel Selector Knob
Gas 
Connection 
Fitting
Hex Plug










