Installation manual

www.usaprocom.com
200020-01A16
INSTALLATION
INSTALLING LOGS
WARNING: Failure to posi-
tion the parts in accordance
with these diagrams or failure
to use only parts specically
approved with this heater may
result in property damage or
personal injury.
CAUTION: After installation
and periodically thereafter,
check to ensure that no yellow
ame comes in contact with any
log. With the heater set to High,
check to see if yellow ames
contact any log. If so, reposi-
tion logs according to the log
installation instructions in this
manual. Yellow ames contact-
ing logs will create soot.
It is very important to install the
logs exactly as instructed. Do
not modify logs. Use only logs
supplied with heater. Each log
is marked with a number. This
number will help you to identify
the logs when installing. After
installing logs, add decorative
cinders around the grate base,
do not place any decorative
cinders on logs or burner.
1. Install pins on log #1 into the two slots
in the bracket attached to rear wall (see
Figure 13).
2. Install pins on log #2 into the two slots in
left side of the middle bracket (see Figure
13 and Figure 14).
3. Install pins on log #3 into the two slots
in right side of the middle bracket (see
Figure 13 and Figure 14).
4. Install pins on log #4 onto the two slots
in the front bracket (see Figure 14 and
Figure 15, page 17).
5. Insert the recessed hole on the bottom of
log #5 onto the pin on log #2 (see Figures
15 and 16, page 17).
Figure 13 - Installing Log #1
Figure 14 - Installing Logs #2 and #3
6. Insert the pin on log #6 into the hole on
log #3 (see Figures 15 and 16, page 17).
IMPORTANT: Make sure logs do not cover
any burner ports. It is very important to install
the logs exactly as instructed. Do not modify
logs. Use only logs supplied with heater.
Slots in Rear Plate
Log #1
Log #2
Log #3
Slots for Log #2
Slots for Log #4
Slots for Log #3