Installation Guide

ManualsBrandsProCom ManualsKitchen24 in. Vented Natural Gas Fireplace Log Set

PC-WAN18-1203

Questions about installation, operation, or troubleshooting? Before returning to

your retailer, call customer service department toll-free at (877)886-5989.

VENTED NATURAL GAS LOGS

MODEL #WAN18N-2 WAN24N-2

WARNING: IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED

EXACTLY, A FIRE MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL

INJURY, OR LOSS OF LIFE.

– Do not store or use gasoline or other ammable vapors and liquids in vicinity of this or any

other appliance.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use any phone in your building.

• Immediately call your gas supplier from a neighbor’s phone. Follow the gas

supplier’s instructions.

• If you cannot reach your gas supplier, call the re department.

– Installation and service must be performed by a qualied installer, service agency

or the gas supplier.

This appliance may be installed in an aftermarket, permanently located manufactured (mobile)

home, where not prohibited by local codes. This appliance is convertible for use with propane/

LP gas by using the MANUAL ON/OFF VALVE/SAFETY PILOT KIT (see ACCESSORIES on

page 11).

This is a gas-red appliance. It uses air (oxygen) from the room in which it is installed.

Provisions for adequate combustion and ventilation air must be provided. Refer to Air For

Combustion and Ventilation section on page 5 of this manual.

CAUTION - FOR YOUR SAFETY

INSTALLER: Leave this manual with the appliance. CONSUMER: Retain this manual

for future reference.

Summary of content (17 pages)

PAGE 1
VENTED NATURAL GAS LOGS MODEL #WAN18N-2 WAN24N-2 CAUTION - FOR YOUR SAFETY WARNING: IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, A FIRE MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE. – Do not store or use gasoline or other flammable vapors and liquids in vicinity of this or any other appliance. WHAT TO DO IF YOU SMELL GAS • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building.
PAGE 2
TABLE OF CONTENTS Important Safety Information....................................................................................................................3 Product Features.................................................................................................................................4 Air For Combustion and Ventilation............................................................................................................5 Installation ............................................
PAGE 3
IMPORTANT SAFETY INFORMATION IMPORTANT: Read this owner’s manual carefully and completely before trying to assemble, operate, or service this heater. Improper use of this heater can cause serious injury or death from burns, fire, explosion, electrical shock, and carbon monoxide poisoning. Only a qualified installer, service agent, or local gas supplier may install and service this product. WARNING: Keep flue open when operating unit.
PAGE 4
11. Do not burn solid fuel in the fireplace after installing the log set. Do not use this log set to cook food or burn paper or other objects. 12. Log set becomes very hot when in use. Keep children and adults away from hot surface to avoid burns or clothing ignition. Log set will remain hot for a short time after shut-down. Allow surface to cool before touching. 13. Carefully supervise young children when they are in the room with log set. 14.
PAGE 5
AIR FOR COMBUSTION AND VENTILATION WARNING: If the area in which the heater may be operated does not meet the required volume for indoor combustion air, combustion and ventilation air shall be provided by one of the methods described in the National Fuel Gas Code, ANSI Z223.1/NFPA 54, the International Fuel Gas Code, or applicable local codes. Today's homes are built more energy efficient than ever. New materials, increased insulation, and new construction methods help reduce heat loss in homes.
PAGE 6
INSTALLATION VENTING SPECIFICATIONS FOR INSTALLATION The fireplace chimney flue and vent must be drafting properly. To check the vent for proper drafting, light a tightly rolled newspaper on one end and place it at the inside front edge of the fireplace. Observe the smoke and be sure the vent is properly drawing it up the chimney. If the smoke spills out into the room, extinguish the flame and remove any obstruction until proper venting is achieved. The chimney flue must remain open a minimum of 3 in.
PAGE 7
Installation and Gas Connection 1. Place the burner pan assembly in the center of the fireplace floor. Make sure the front of pan faces forward. Fig. 5 – Connecting Gas to Appliance 2. Thread the gas supply fitting to the fireplace gas supply pipe. Use thread sealant. Gas Connector Tube 3. Install adapter fitting onto the burner inlet fitting using thread sealant on male threads of burner inlet fitting (see Fig. 5). Burner Pan Assembly (Facing Front of Fireplace) 4.
PAGE 8
CHECKING GAS CONNECTIONS WARNING: Test all gas piping and connections for leaks after installing or servicing. Correct all leaks immediately. WARNING: Never use an open flame to check for a leak. Apply a mixture of liquid soap and water to all joints. Bubbles forming show a leak. Correct all leaks immediately. Pressure Testing Gas Supply Piping System Test Pressures In Excess Of 1/2 PSIG ( 3.5kPa ) 1.
PAGE 9
INSTALLING LOGS (WAN18-2 & WAN24-2) WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury. Provided Logs: 8 CAUTION: After installation and periodically thereafter, check to ensure that no yellow flame comes in contact with any log. With the heater set to High, check to see if yellow flames contact any log.
PAGE 10
OPERATION FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor. WHAT TO DO IF YOU SMELL GAS • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building.
PAGE 11
CARE AND MAINTENANCE ● Keep the area around the log set clean and clear of debris. ● Occasionally, you may use a soft bristle brush to clean logs. ● Once every year a qualified agency or certified chimney sweep should examine and clean the venting system of the fireplace. ACCESSORIES Purchase these fireplace accessories from your local dealer. If they can not supply these accessories, contact customer service department for information. Equipment shutoff valve EQUIPMENT SHUTOFF VALVE For all models.
PAGE 12
TROUBLESHOOTING WARNING: If you smell gas: • Shut off gas supply. • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions. • If you cannot reach your gas supplier, call the fire department. IMPORTANT: Operating heater where impurities in air exist may create odors.
PAGE 13
REPLACEMENT PARTS NOTE: Use only original replacement parts. This will protect your warranty coverage for parts replaced under warranty. PARTS UNDER WARRANTY Call Customer Service toll free at (877)886-5989 for referral information.
PAGE 14
PARTS LIST (WAN18N-2) This list contains replaceable parts for your heater. When ordering replacement parts, follow the instructions listed under Replacement Parts on page 13 of this manual. Part. 1 2 3 4 Description Part # 3/8 in. Female x 5/8 in.
PAGE 15
PARTS LIST (WAN24N-2) This list contains replaceable parts for your heater. When ordering replacement parts, follow the instructions listed under Replacement Parts on page 13 of this manual. Part. 1 2 3 4 Description Part # 3/8 in. Female x 5/8 in.
PAGE 16
PAGE 17
WARRANTY INFORMATION Keep This Warranty IMPORTANT: We urge you to fill your warranty registration card within TEN(10) days of date of installation, complete with the entire serial number which can be found on the rating plate. Retain this portion of the card for your record. Always specify model and serial numbers when communicating with customer service. We reserve the right to amend these specifications at any time without notice. The only warranty applicable is our standard written warranty.