Installation Guide

10
OPERATION
FOR YOUR SAFETY READ BEFORE LIGHTING
BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the oor because some gas is
heavier than air and will settle on the oor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the re department.
1. STOP! Read the safety information above.
2. Turn the gas shutoff valve to OFF.
3. Wait ve (5) minutes to clear out any gas. If you still smell gas, STOP! Follow the safety information above. If you don't smell
gas, go on to the next step.
4. Light a match and lay it on top of the pan material about 2 in. from the end of the supply side of the pan.
5. Slowly turn the gas shutoff valve ON until the burner ignites. If the burner doesn't ignite within 10 seconds with the match
burning, turn the shutoff valve OFF and repeat steps 1 through 4 again.
LIGHTING INSTRUCTIONS
GAS SHUTOFF VALVE OPERATION
Flame Adjustment
Adjust the ame ON/OFF by turning the gas shutoff valve counterclockwise to open or clockwise to
close, as necessary.
Shutting Off Appliance
Turn gas shutoff valve clockwise to the OFF position.
WARNING: If you do not follow these instructions exactly, a re or explosion may result causing property damage,
personal injury or loss of life.