User's Manual
Table Of Contents
- User’s Guide
- Wireless LAN AP-Router
- Model:
- PW8540IM
- IEEE 802.11b/g
- System Requirement
- Installation Instructions
- Configuring Windows for IP Networking
- Collecting ISP Information
- Setup
- Global Address
- Wireless
- Tools
- Status
- DHCP
- Log
- Statistics
- Printer
- Virtual Servers
- Filters
- IP/URL Block
- Special Apps
- DMZ Host
- MAC Clone
- Dynamic DNS
- Proxy DNS
- SNMP
- Static Routing
- FEDERAL COMMUNICATIONS COMMISSION (FCC) REQUIREMENTS, PART 15
- REGULATORY INFORMATION / DISCLAIMERS
BASIC FUNCTIONS: WIRELESS
FIGURE 3-8: Default Values for Radio Settings
6. Optional. If you have enabled Distribution System, type the physical
addresses of distributed client PCs in a wireless network in the Peer
AP MAC Address 1-8 boxes, seen in FIGURE 3-9:
FIGURE 3-9: Peer AP MAC Addresses for Distribution Systems
7. When you have completed editing all the settings, click Apply, or
click Cancel to undo your changes.
To Set Wireless Security Parameters:
1. Click Security Settings on the Wireless page.
The Security Settings appears, seen in FIGURE 3-10:
Page 22 of 77