User's Manual
Table Of Contents
- User’s Guide
- Wireless LAN AP-Router
- Model:
- PW8540IM
- IEEE 802.11b/g
- System Requirement
- Installation Instructions
- Configuring Windows for IP Networking
- Collecting ISP Information
- Setup
- Global Address
- Wireless
- Tools
- Status
- DHCP
- Log
- Statistics
- Printer
- Virtual Servers
- Filters
- IP/URL Block
- Special Apps
- DMZ Host
- MAC Clone
- Dynamic DNS
- Proxy DNS
- SNMP
- Static Routing
- FEDERAL COMMUNICATIONS COMMISSION (FCC) REQUIREMENTS, PART 15
- REGULATORY INFORMATION / DISCLAIMERS
BASIC FUNCTIONS: WIRELESS
5. Next to Enhanced Security, select either Enable or Disable. If you
choose to enable the enhanced security feature, go to Step 6.
6. Optional. If you have enabled Enhanced Security, you can choose to
hide your SSID (Service Set Identifier) in Beacon frame.
7. When you have completed editing all the settings, click Apply, or
click Cancel to undo your changes.
To Set WEP Keys:
1. On the Security Settings page, enable the Encryption and click Set
WEP Keys.
The Set WEP Keys window appears, seen in FIGURE 3-11:
FIGURE 3-11: Set WEP Keys Window
2. Select either 64 Bit or 128 Bit next to Encryption Level.
Note – 128 Bit encryption can provide you a more secure
encryption algorithm, but it will slow down your network
data transmission rates.
3. If you want to generate WEP Keys automatically, do the following:
No. Action
1
Select Automatic next to WEP Key Type.
Page 24 of 77