User's Manual
Table Of Contents
- User’s Guide
- Wireless LAN AP-Router
- Model:
- PW8540IM
- IEEE 802.11b/g
- System Requirement
- Installation Instructions
- Configuring Windows for IP Networking
- Collecting ISP Information
- Setup
- Global Address
- Wireless
- Tools
- Status
- DHCP
- Log
- Statistics
- Printer
- Virtual Servers
- Filters
- IP/URL Block
- Special Apps
- DMZ Host
- MAC Clone
- Dynamic DNS
- Proxy DNS
- SNMP
- Static Routing
- FEDERAL COMMUNICATIONS COMMISSION (FCC) REQUIREMENTS, PART 15
- REGULATORY INFORMATION / DISCLAIMERS
BASIC FUNCTIONS: TOOLS
FIGURE 3-14: Tools Page
2. Type the Old Password in the box. The default password is 1234.
3. Type a New Password in the box.
Note - Password must be less than 64 characters.
4. Type the new password in the Confirm Password box.
To Restore the Factory Default Configuration:
1. On the Tools page, click Restore to Default next to Restore Factory
Defaults.
The Warning dialog box appears, see FIGURE 3-15:
FIGURE 3-15: Warning Dialog Box
2. Click OK.
Important:
▪ Restoring the default factory settings will reset all of the
router configurations in every page, so we recommend that
Page 29 of 77