I N STA L L AT I O N G U I D E
G E N E R A L I N F O R M AT I O N & L I M I TAT I O N S PROCORE™ is designed to be installed as a residential “floating floor”. Do not secure individual planks to the subfloor with mechanical fasteners or adhesives. Do not install cabinets, kitchen islands, or other non-movable objects on top of or through the flooring. The installation and maintenance instructions along with the limited warranty, must be read, understood, and followed before installation commences.
Waterproof: Although this flooring is waterproof, it is not a waterproof barrier. The following requirements are precautionary as high moisture, combined with any organic material trapped beneath the flooring may facilitate mold growth. Property damage and/or resulting health issues as a direct result of mold is not covered by the limited warranty of this flooring. Do not leave liquid on the flooring surface, wipe up spills immediately, and allow the floor to dry before allowing foot traffic.
Cutting: To cut the flooring, measure, mark and carefully use a sharp utility knife and a framer’s square to score the flooring (several times) and then snap it along your cut and trim off the backing. Alternatively, cut using a guillotine style tile cutter. For complicated cuts, it is helpful to gently warm the flooring first by using a hair dryer or heat gun (~ 6-inches away) before cutting. Important: Do not directly tap any part of the locking mechanism as that will cause permanent damage.
1-inch from joint Side Joints: For the following rows, insert the long side tongue of the flooring into the previously installed plank groove at an angle of about 25°, ensure the joint is seated properly, slide the flooring towards the previous end joint (or spacer) until perfectly aligned. While pressing into the long side, lower the flooring into position. Complete the end joint, as before and continue with the installation.
